The Audi TT comes with a inventory dual exhaust that’s restricted due to the design and materials it’s made out of. There are aftermarket dual exhaust methods you possibly can set up onto your Audi TT your self utilizing a number of fundamental auto instruments.
Audi TT Aftermarket Dual Exhaust Installation Instructions
1. Spray the bolts that maintain the clamps collectively on the exhaust with WD-40 to loosen them so they’re simply eliminated later.
2. Park your automobile on rear stands and put it in “Park.” Let your engine and exhaust cool fully. This would possibly take so long as 20 minutes. Pop the hood and disconnect the negative cable from the battery terminal.
3. Loosen the 2 bolts on the clamp that holds the exhaust system, utilizing a socket wrench with a 17 millimeter socket attachment. Open the clamps so they’re loosened.
4. Use a giant flat-head screwdriver to pry the grommet off of the middle hanger of the exhaust. Afterwards, connect a thirteen millimeter socket to the socket wrench and unbolt the 2 brackets that maintain the muffler in place. When the brackets have been unbolted, the burden of the exhaust system shall be linked to at least one hanger nonetheless.
5. Rotate the muffler barely forwards and backwards to confirm that the compression coupler is free. You may have to loosen the clamps extra if the pipe is just not transferring. If the pipe continues to be caught, you’ll be able to faucet it with a hammer on the clamp space to maneuver it free.
6. Use a giant flat-head screwdriver to remove the final hangar that’s holding the exhaust system. Put together to carry the exhaust as you information it down out of the automotive. Be sure the exhaust system doesn’t relaxation on the catalytic converter, or it might probably grow to be broken.
7. Bend the brackets of the exhaust system if wanted to assist assist the exhaust within the cutouts of the bumper.
8. Take the inventory brackets off the inventory exhaust. Put the twin exhaust system into place the place the outdated exhaust was, then re-connect the compression coupler. Re-connect the rear hanger to carry the muffler into place.
9. Re-connect the brackets, then tighten the bolts to safe the dual exhaust into place.
Read more : How to Install a Dual Exhaust on an Audi TT
